Automation Inc. EP-1 Instrukcja Obsługi Pobierz pdf (Strona 6)

T4x-SERIES QUICKSTART GUIDE

2. Remove the sensor protection label (dust cap) by pulling it off of the base.

3. Mount a lens by slowly screwing it onto the base until it arrives at the mechanical stop.

Figure 1 – Assembling the Camera and Lens

4. To keep dust and dirt off of the lens during mounting, temporarily replace the lens cover.

Connect the System

In the typical standalone layout shown in the figure below, an EtherNet host is connected to the

camera. The camera can use an external trigger to signal image acquisition.

The CBX is used to facilitate the connection between the camera and the host interface, external

trigger, and optional input and output devices.

T4x-Series™ Standalone Layout to Ethernet Host

CAB-GE0x

CAB-PG-0002

+ BA400

CAB-SCSxx

PG-120

Ext. Trigger

CBX500

I/O

Ethernet Host

(Data collection + T4x-

Series configuration)

Camera

Lens

Lens Cover

Protective Film on front of cover

(remove before calibration)

Camera

Anti-vibration components

(optional)

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Brak uwag

Automation Inc. EP-1 Instrukcja Obsługi Strona 6